I only change DiSEqC to Pos B/Opt A, apply and save and I "Scan selected" with positive result.Ĭhange DiSEqC to Pos A/Opt B, apply and save and I "Scan selected" with positive result.Ĭhange DiSEqC to Pos B/Opt B, apply and save and I "Scan selected" with positive result. Keeping everything as discribed in "Test software setup", the same Within transponder list 19.2 I select frequency 11347 (free to air) and I "Scan selected", negative result Within transponder list 23.5 I select frequency 12363 (free to air) and I "Scan selected", positive result The DiSEqC settings are set as following and apllied and saved: I added both tuners in Transedit > settings > hardware where all groups (A to H) are selected and tuner A is disabled.Īdded transponder list for 19.2 and 23.5 and both are set to group A. Using the software Transedit locally and without DVBViewer media. I simplified my setup for testing purpaces and did the following tests to confirm my suspision:Ĭonnected only to 1 tuner (tuner port B) to 1 switch, connected that switch to 2 LNB's (Input A & B of the switch) Trasnedit and DVBViewer Pro are not generating the correct DiSEqC command so that the Diseqc Switch would switch ports. TBS6982 card has 2 tuners, both tuners have there own DiSEqC Switch (Venton 418-P) and each Switch is connected to 3 LNB's (ALPS twin LNB)
0 Comments
Leave a Reply. |